CRC Industrial Electrical QD-Contact Cleaner 500ml Offers

The QD-Contact cleaner is a highly-purity solvent that can be used on most electronic equipment. It is designed to remove hydrocarbons and other harmful substances from the surface. This cleaning product is also suitable for applications where lower-flash point solvents are used.

Features 

• Quick-drying
• Effectively removes light contaminants, dust, dirt, fingerprints, traces of light oil, and moisture
• No ozone-depleting action (ODP = 0,00)
• Reduces contact resistance, arcing, and wear
• Extends the life of sensitive equipment
• Non-conductive and non-corrosive
• Leaves no residue
• Safe on commonly used plastics, rubbers, and coatings
• Convenient 360° (upside-down) spray valve for aerosols
• High purity CO2 propellant, giving an active product content of 95%

Applications:
Applications  Ideal for applications where lower flashpoint solvents may be used and where sensitive plastics are present:

• Contactors
• Switches 
• Sensors
• Relays 
• Motor controls 
• PCB 
• Terminals 
• Tape heads 
• PC’s 
• Telephones 

Directions

• Spray liberally on the surface to be cleaned and allow to run off. Use extension tube for precision application. 
• Use an abrasive on surfaces with carbon deposits or oxidation; remove residue with intermittent spray. Re-lubricate with CRC 2-26 if necessary.
• Highly flammable formulation. Do not spray on energized electrical equipment or circuits; de-activate before product application and extinguish all flames, pilot lights, and heaters 
• During use, flammable vapors may accumulate, especially in closed equipment. Use adequate ventilation and maintain ventilation until vapors are gone. Allow drying thoroughly before reactivating systems.
• Observe care in applications on highly sensitive plastics, adhesive-mounted, or stressed parts.